Enreach DECT 600 Firmware Pack v.7.80.B0100 (v1) released

The information in this article applies to the following products:

• Enreach DECT BS 600 L
• Enreach DECT BS 600 S
• Enreach DECT BS 600 Outdoor
• Enreach DECT R 600 Repeater
• Enreach DECT HS 630
• Enreach DECT HS 650
• Enreach DECT HS 670
• SwyxPhone D510
• SwyxPhone D565

SUMMARY

Enreach has released a new firmware package for its DECT 600 Multi- and Microcell systems. The package contains current firmware versions for all Enreach DECT 600 components and for the SwyxPhone D510/D565 released for operation on Enreach DECT 600 systems.

This firmware pack supports the new "Swyx DECT Integration for Enreach DECT 600" with Swyx 14.21, as well as the standard installation (without Swyx DECT Integration) with Swyx 14.00 and higher.

For installations with Swyx DECT-Integration, the firmware package v.7.80.B0100 (v1)  is automatically made available in the Swyx Control Center in a timely manner. For installations whose components are updated via a local software distribution, as well as for standard installations, suitable firmware packages will be made available for download in the Enreach Partner Net on a short notice.

INFORMATION

Enreach has released a new firmware package for the Enreach DECT 600. The package contains the latest firmware versions for all Enreach DECT 600 components and all SwyxDECT 500 components that are approved for use with Enreach DECT 600.

The release mainly contains important bug fixes relating to general system stability and the Swyx DECT Integration for Enreach DECT 600 feature introduced with Swyx 14.21:

• Fixed: Call gets terminated after hold retrieve on handset due to wrong handling of codec changes. 
• Fixed: Emergency call not possible.
• Fixed: Not able to fetch all logfiles.
• Fixed (prerequisite Swyx 14.25): DECT integration for Enreach DECT 600 - repeaters must still be set up and updated in the Admin Web-UI. 

Note on initial set-up Swyx DECT Integration for Enreach DECT 600: 

For the initial set-up of the Swyx DECT Integration for Enreach DECT 600 or the migration of an existing standard installation, please read the documentation carefully (Swyx Online Manual). Please note that all base stations must be updated to 7.60.B0201 or higher before you start the integration. Following you can update the handsets via the SCC.

Known issue:

• Standard (non integrated) installation: Orange blinking LED at the base station even when the system is set-up correctly and is working properly. This blinking LED is an artefact of the Swyx DECT Integration feature. Workaround: Open the Enreach DECT 600 Web Administration and click in the left menue on “Management”. Go to the paragraph “Configuration” and enable the parameter “Configuration Server Address Lock". Following the LED should be switch to steady green.

For more information about the functionality of the firmware Pack v.7.80.B0100 (v1) please refer to the attached release notes. Please note especially the downgrade instructions if you intend to downgrade a DECT BS 600 L to an older firmware version, e.g. to add it to an existing SwyxDECT 500 system.

If you only want to update individual units, this can be done during operation. However, if you want to update the entire system to v.7.80.B0100 (v1), please note the information on using a maintenance window in the release notes.

The following article (Important Notes on the Firmware Update) gives you additional information for installing this firmware.

• Release Notes Enreach DECT 600 - Firmware Pack Version 7.80B0100.pdf400 KB